TM-9-2520-215-34

CROSS-DRIVE TRANSMISSION ASSEMBLY

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE

DECEMBER 2005

  TM-9-2520-215-34 - Page 112 of 508

TM 9--2520--215--34
0024 00--2
DETERMINING NOMINAL SHIM FOR STEER BEVEL DRIVE GEAR –
CONTINUED
0024 00
DETERMINING NOMINAL SHIM FOR STEER BEVEL DRIVE GEAR – Continued
6. Record dimension indicated by D on Figure 1 of WP 0020 00. This dimension is stamped in housing (1).
D ---5.212
E
---9.560
F
---9.985
1
7. Record actual shim dimension used for main bearing support (WP 0022 00).
8. Calculate nominal shim required by substituting dimensions recorded in Steps 4 through 7, above, for MD2, D,
and actual S1 in formula:
(D + actual S1) – (MD2 + A) = nominal S2. Select proper combination of shims to equal the required shim
pack thickness.
CAUTION
Before bolting assembly down tightly, be certain that steer bevel drive gear is positioned toward
right side of transmission, far enough to prevent interference with drive gear.
9. Install nominal shim pack and install low and reverse range planetary carrier assembly (with bevel gear and thrust
washer) into transmission housing. Follow procedures in WP 0074 00.
END OF WORK PACKAGE


Back to Top