TM-9-2520-215-34

CROSS-DRIVE TRANSMISSION ASSEMBLY

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE

DECEMBER 2005

TM-9-2520-215-34 - Page 104 of 508

TM 9--2520--215--34

0021 00--2

ADJUSTING DRIVE SHAFT PRELOAD – CONTINUED

0021 00

ADJUSTING DRIVE SHAFT PRELOAD – Continued

3. Check endplay of drive shaft (3). Use dial indicator (4) to check endplay.

3

4

NOTE

Tap inner race of right drive shaft bearing down against spanner nut while backing off nut.

4. After all endplay is eliminated, back off spanner nut (2) (tightened in Step 2 above) until 0.002 to 0.005 inch

endplay can be measured.

2