TM-9-2520-234-35
POWER TRAIN ASSEMBLY; ALLISON MODEL XTG411-2A
TECHNICAL MANUAL; FIELD AND DEPOT MAINTENANCE MANUAL
JULY 1962
TM-9-2520-234-35 - Page 21 of 323
LIST OF WARNING S
●
White lead is toxic. To avoid injury, do not use white lead.
●
Transmission and transmission components are heavy and can
crush you. Have a ground guide check slings and lifting devices
for cuts, breaks or wear before and during hoisting. Slings and
lifting devices can break and cause injury or death. To avoid
injury, do not stand under transmission or components when
lifting them.
●
Fumes from burning Teflon can cause serious injury or death.
Because clutch piston seal rings and step-joint seal rings are
made of Teflon, do not get rid of them by burning.
●
Compressed shop air will not exceed 30 psi (pounds per square
inch). Regulator assembly must be attached to compressor .
To avoid injury, use only with effective chip-guarding and
personal protective equipment (goggles/faceshield, gloves ,
etc.) .
●
Dry Cleaning Solvent P-D-680 is toxic and flammable. To avoid
injury, wear protective goggles and gloves and use in a
well-ventilated area. Avoid contact with skin, eyes, and
clothes, and do not breathe vapors. Do not use near open fire
or excessive heat. The flash point for Type I dry cleaning
solvent is 100°F (38°C), and for Type II is 138°F (50°C). If you
become dizzy while using dry cleaning solvent, get fresh air
immediately and get medical aid. If contact with eyes i s
made, wash your eyes with water and get medical aid immedi-
ately .
Change 2 a .
Back to Top
