TM-9-2520-246-34-1

TRANSMISSION MODEL 3053A; TRANSMISSION TRANSFERS MODEL T-136-21 AND MODEL T-136-27; POWER TAKEOFFS MODEL WN-7-28, MODEL WND-7-28 AND MODEL P-136-C

TECHNICAL MANUAL; MAINTENANCE, DIRECT SUPPORT AND GENERAL SUPPORT LEVEL

JANUARY 1981

TM-9-2520-246-34-1 - Page 107 of 418

TM 9-2520-246-34-1

2-11. FINAL ASSEMBLY. The following paragraphs give instructions to assemble

the transmission subassemblies into a final assembly.

NOTE

Keep all parts clean and protected from dust and

dirt.

Coat all oil seals, gears, and shafts with

engine lubricating oil during assembly. Use new

snaprings and gaskets during assembly.

a.

Reverse Idler Gear Assembly.

FRAME 1

1.

Put grease on back of two thrust washers (1).

2.

Put two thrust washers (1) in transmission case (2) as shown. Grease will

hold two thrust washers in place.

3.

Put reverse idler gear assembly (3) between two thrust washers (1) and hold

it in place.

NOTE

Make sure milled side of reverse idler gear shaft (4)

faces outside transmission case (2).

4.

Using soft face hammer, tap in reverse idler gear shaft (4).

END OF TASK

2-87