TM-9-2520-246-34

TRANSMISSION MODEL 3052, NSN 2520-00-347-4520

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT; MAINTENANCE MANUAL

MAY 1978

TM-9-2520-246-34 - Page 104 of 153

TM 9-2520-246-34

Figure 5-9. Removal of Output Shaft Rear Bearing.

f. Output Shaft Rear Bearing.

(1) Push or tap output shaft rearward enough to

allow the rear bearing (fig. 5-9) to be removed.

(2) Using a universal puller remove the output

shaft rear bearing. (See fig. 5-9.)

NOT E

Use a wooden block or press to install rear

bearing on the shaft and into the rear

bearing bore.

g.

Output Shaft and High-Speed Gear.

(1) After the output shaft rear bearing is

removed, push the output shaft back into place.

Remove the snapring securing the high-speed gear and

Figure 5-11. Removal of Output Shaft, High-Speed

Gear, and Front Bearing.

spacer. (See fig. 5-10.)

(2) Push or tap the output shaft and front

bearing from the case. (See fig. 5-11.) Lift the sliding

gear out of the case.

h. Reverse Gear.

(1) Remove the cotter pin securing the reverse

gear pin and remove the reverse gear pin. (See fig.

12.)

5-

(2) Using a soft drift pin, tap the reverse

gearshaft and front roller bearing from the case.

Remove the front roller bearing from the shaft.

(3) Remove the reverse gear thrust washers (fig.

5-12).

Figure 5-10. Removal of Output Shaft High Speed Gear

Snapring and Spacer.

Figure 5-12. Removal of Reverse Gear.

5-5