TM-9-2520-246-34

TRANSMISSION MODEL 3052, NSN 2520-00-347-4520

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT; MAINTENANCE MANUAL

MAY 1978

TM-9-2520-246-34 - Page 111 of 153

TM 9-2520-246-34

Legend for fig. 5-20:

KEY

ITEM

KEY

ITEM

A

B

C

D

E

F

G

H

J

Housing

Sliding clutch sleeve

Shifter fork

Fork locking screw

Retainer

Spring

Ball

Retainer

Shifter shaft

P

K

L

M

N

Q

R

S

T

Boot

Oil seal

Output shaft

Key

Oil seal

Snapring

Snapring

Bearing

Output shaft gear

Figure 5-20. Rear Output Shaft Housing —

Sectional View.

Section VI. REPAIR

5-16. Disassembly and Assembly of Accessory

Drive.

a. Rear Output Shaft Housing and Shifter Shaft

Retainer, Ball, and Spring.

(1) Remove the five capscrews securing the rear

output shaft housing to the power takeoff case. (See

fig. 5-21.) Remove the housing and housing gasket.

Discard the gasket.

(2) Remove the retainer, spring, and ball from

the rear output shaft housing. (See fig. 5-21.)

5-12

(MODEL WND-7-28)

NOTE

During assembly, always install a new

gasket.

b. Shifter Shaft and Shifter Shaft Fork.

(1) Cut safety wire and remove from housing.

(See fig. 5-22.)

(2) Remove the lock screw securing the shifter

fork to the shifter shaft and remove the shaft and fork

from the housing. (See fig. 5-22.)