TM-9-2520-246-34
TRANSMISSION MODEL 3052, NSN 2520-00-347-4520
TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT; MAINTENANCE MANUAL
MAY 1978
TM-9-2520-246-34 - Page 120 of 153
TM 9-2520-246-34
Section XI. TEST AND ADJUSTMENT (MODEL P-136-C)
5-28. General.
Tests and adjustments can either be
the movement of lubricant through the hole. Replace
accomplished by installation on the vehicle or on a
pipe plug.
transfer unit that is coupled to an engine and
transmission installed on a dynamometer.
b. Adjustment.
a. Operation.
Test power takeoff model P-136-C for
(1) There are no adjustments required on the
the following:
power takeoff assembly.
(1) Quiet operation.
(2) Refer to TM 9-2320-209-20/1 for the power
(2) Smooth and positive shifting.
takeoff linkage adjustment.
(3) Observe for lubricant leaks.
(4) Inspect oil pump operation. Remove pipe
5-29. Lubrication.
Lubrication of the power takeoff is
plug covering the shifter shaft setscrew and observe
provided by the transfer. Refer to LO 9-2320-209-12/1
for lubrication instructions.
Section XII. REPAIR AND REPLACEMENT STANDARDS
(MODEL P-136-C)
5-30. General.
The repair and replacement standards
included herein give the minimum, maximum, and key
clearance of new parts. The standards also give wear
limits which indicate the point to which a part or parts
may be worn before replacement, in order to receive
maximum service with minimum replacement.
Normally, all parts which have not been worn beyond the
dimensions shown in the “Wear Limits” column, or
damaged by corrosion, will be approved for service. An
asterisk (*) in the “Wear Limits” column indicates that
the part or parts should be replaced when worn beyond
the limits given in the “Size and Fit of New Parts”
column. In the “Size and Fit of New Parts” column, the
letter “L” indicates a loose fit (clearance) and the letter
“T” indicates a tight fit (interference).
5-31. Repair and Replacement Standard Points of
Measurement.
Figure 5-36 and table 5-5 provide the
repair and replacement standard points of measurement
for power takeoff model P-136-C.
5-21 (5-22 blank)
Back to Top
