TM-9-2520-254-34

TRANSMISSION, AUTOMATIC, ALLISON, MODEL TX100-1

TECHNICAL MAUAL; DIRECT AND GENERAL SUPPORT MAINTENANCE MANUAL

OCTOBER 1971

TM-9-2520-254-34 - Page 117 of 126

Table 6-1.

CHAPTER 6

REPAIR AND OVERHAUL (REBUILD) STANDARDS

6-1. Standard Torque Specifications

Refer to table 6-1 for standard torque specifications

for bolts, nuts, and screws. Special torque

specifications are included in applicable overhaul

(rebuild) and assembly sections.

6-2. Spring Specifications

Refer to table 6-2 for specifications for all springs in

the transmission.

6-3. General Wear Limits Information

a. Wear Limits Definition.

The wear limits

indicate the dimensions to which a part may wear

before it must be replaced. Normally any part not

worn beyond its wear limit will be approved for

continued use, if it is not otherwise damaged.

b. Points

of

Measurement.

Points of

measurement of all critical dimensions are in-

dicated by lower-case letters in the referenced

figures.

c. Wear Limits Tabulation.

All wear limits

applicable to transmission parts are tabulated in

paragraph 6-4 below.

d. Letters and Symbols in Tabulation.

The

“Size and Fit of New Parts” column indicates fit by

T or L. T denotes a tight (interference) fit; L

denotes a loose (clearance) fit.

6-4. Wear Limits

Refer to table 6-3 for wear limits for direct and

general support, maintenance operations.

NOTE

Refer to paragraph 5-3 for inspection

recommendations applicable to all trans-

mission componets.

6-1