TM-9-2520-270-34

HYDROMECHANICAL CROSSDRIVE, TRANSMISSION HMPT 500 AND TRANSMISSlON CONTAINER ASSEMBLY

TECHNICAL MANUAL; DIRECT AND GENERAL SUPPORT MAINTENANCE

NOVEMBER 1984

TM-9-2520-270-34 - Page 143 of 933

TM 9-2520-270-34

1. REMOVE CROSS SHAFT ASSEMBLY. See task REPLACE

CROSS SHAFT ASSEMBLY, page 4-458.

2. WAS CROSS SHAFT ASSEMBLY BEARING PRELOAD

CORRECT?

Corrective action:

1. REPLACE CONTROLLER

ASSEMBLY.

2. RECORD CONTROLLER

ASSEMBLY FAILURE ON DA FORM

2407 AND RETURN WITH

CONTROLLER TO DEPOT.

1. REPAIR CROSS SHAFT ASSEMBLY,

1. PERFORM CORRECTIVE ACTIONS RECORDED ON

DA FORM 2404.

2. WAS MAIN HOUSING ASSEMBLY CLEANED?

1. Assemble transmission. See

task CLEAN MAIN HOUSING

ASSEMBLY, page 4-155.

1. Install cross shaft assembly. See task REPLACE CROSS

SHAFT ASSEMBLY, page 4-458.

2. Install positive clutch. See task REPLACE POSITIVE

CLUTCH, page 4-356.

3. DELETED.

4. Install left-hand intermediate housing assembly. See task

REPLACE LEFT-HAND INTERMEDIATE HOUSING

ASSEMBLY, page 4-220.

5. Install left-hand single disk brake. See task REPLACE

LEFT-HAND SINGLE DISK BRAKE, page 4-255.

6. Install right-hand intermediate housing assembly. See task

REPLACE RIGHT-HAND INTERMEDIATE HOUSING

ASSEMBLY, page 4-170.

7. Install right-hand single disk brake. See task REPLACE

RIGHT-HAND SINGLE DISK BRAKE, page 4-197.

8. Install disconnect clutch assembly. See task REPLACE

DISCONNECT CLUTCH ASSEMBLY, page 4-78.

9. Install disconnect clutch. See task REPLACE

DISCONNECT CLUTCH, page 4-52.

10. Assemble transmission. See task INSPECT TRANSMISSION

FOR CONTAMINATION, page 4-67.

Change 3

2-79

page 4-464 .