TM-9-2520-270-34

HYDROMECHANICAL CROSSDRIVE, TRANSMISSION HMPT 500 AND TRANSMISSlON CONTAINER ASSEMBLY

TECHNICAL MANUAL; DIRECT AND GENERAL SUPPORT MAINTENANCE

NOVEMBER 1984

TM-9-2520-270-34 - Page 599 of 933

TM 9-2520-270-34

NOTE

Thrust washer can be in carrier.

6. REMOVE THRUST WASHER (1) FROM

SPUR GEAR (2).

7. INSPECT THRUST WASHER (1)

FOR DAMAGE. See page 2-5.

a. Replace thrust washer if damaged.

9. PLACE OUTPUT HOUSING (7) ON TWO

WOOD BLOCKS SO THAT CARRIER (8)

IS FREE TO ROTATE.

10. INSTALL OUTPUT HOUSING

INSTALLER (9) INTO SPLINED

OUTPUT SHAFT (10).

8. REMOVE REMOVAL ASSEMBLY (3)

a. Unscrew two screws (4) and remove

removal assembly (3).

b. Install two lock washers (5) and

screws (6).

11. USING 3/8-INCH DRIVE HINGED

HANDLE AND 3/4-lNCH SOCKET,

ROTATE CARRIER (8).

a. If carrier (8) cannot be rotated, remove

output installer (9) and go to step 12.

If carrier can be rotated, remove

installer and go to step 13.

12. REPAIR RIGHT-HAND OUTPUT

HOUSING, page 4-279.

4-272

Change 1