TM-9-2520-270-34

HYDROMECHANICAL CROSSDRIVE, TRANSMISSION HMPT 500 AND TRANSMISSlON CONTAINER ASSEMBLY

TECHNICAL MANUAL; DIRECT AND GENERAL SUPPORT MAINTENANCE

NOVEMBER 1984

TM-9-2520-270-34 - Page 604 of 933

22. (DELETED)

23. INSTALL COVER (1) IF REMOVED.

a. Install new gasket (2) and cover (1).

b. Using 3/8-inch drive brace handle and

7/16-inch socket, install eight new lock

washers (3) and screws (4).

24. USING 3/8-lNCH DRIVE TORQUE

WRENCH AND 7/16-lNCH SOCKET,

TORQUE EIGHT SCREWS (4) TO

75-85 in-lb (86-98 cmkg).

25.

INSTALL OUTPUT HOUSING

INSTALLER (5) INTO SPLINED

OUTPUT SHAFT (6).

TM 9-2520-270-34

WARNING

Fixture removal assembly must

be Installed in position shown.

Out housing is heavy. im-

proper installation of removal

assembly can cause an uneven

lift and injury to personnel.

26. INSTALL REMOVAL ASSEMBLY (7).

a. Remove two screws (8) and lock

washers (9). Discard lock washers.

b. Put removal assembly (7) on

carrier (10).

c. Tighten two screws (11).

GO TO NEXT PAGE

Change 1

4-275