TM-9-2520-270-34

HYDROMECHANICAL CROSSDRIVE, TRANSMISSION HMPT 500 AND TRANSMISSlON CONTAINER ASSEMBLY

TECHNICAL MANUAL; DIRECT AND GENERAL SUPPORT MAINTENANCE

NOVEMBER 1984

TM-9-2520-270-34 - Page 846 of 933

TM 9-2520-270-34

7.

8.

SLIDE (1), SPRING (2), AND

RETAINER (3).

USING RETAINING-RING PLIERS,

REMOVE RETAINING RING (4).

DISCARD RETAINING RING.

9. CHECK HOUSING (5).

a.

b.

4-508

Using small hole gage set and

micrometer caliper set, measure

bore (6) in both ends of housing (5).

Do not measure threads.

If either measurement of bore (6) is

greater than 0.6256 inch (15.890 mm),

replace valve assembly and go to

step 14.5. If not, go to step 10.

Change 2

10. CHECK HOUSING (5).

a.

b.

Using small hole gage set and

micrometer caliper set, measure

bore (7) in both ends of housing (5).

Do not measure threads.

If either measurement of bore (7) is

greater than 0.5006 inch (12.715 mm),

replace valve assembly and go to

step 14.5. If not, go to step 11.

REMOVE DIRECTIONAL CONTROL