TM-9-2520-272-34P
CROSS DRIVE TRANSMISSION WITH CONTAINER MODEL X200-4 & 4A
TECHNICAL MANUAL; INTERMEDIATE, DIRECT, AND GENERAL SUPPORT MAINTENANCE MANUAL (INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST)
TM-9-2520-272-34P - Page 18 of 488
TM 9-2520-272-34&P
HOW TO USE THIS MANUAL (Continued)
If the part shown for Item 12 looks like the part you want, go to page 16-1 following Figure 16
and go down the ITEM NO column (Col. 1) to number IL To the right of item number 12 is SMR
code PAHZZ. To the right of PAHZZ is FSCM code 73342. To the right of 73342 is part
number 8623101. To the right of 8623101 is the part name: Seal, outer.
The quantity (QTY)
column shows a requirement for 1.
If you do not know the NSN for a part, but you have the manufacturer’s part number, locate the
manufacturer’s part number in the RPSTL index.
The STOCK NUMBER column beside the
PART NUMBER column will provide you with the NSN.
If you do not know the NSN and you do not know the manufacturer’s part number, thumb
through the illustrated parts section of the RPSTL until you come to the functional group you
need. Look for an illustration that has the part you need, then take the item number shown in
the illustration for that part; make a note of the figure number shown at the bottom of the
illustration. Go back to the index beginning at RPSTL page I-1 and search through the index
pages until you find your figure and item number in the FIG and ITEM columns. The NSN,
manufacturer’s part number and FSCM will be listed on the line with your figure and item
number.
EXPENDABLE SUPPLIES AND MATERIALS LIST
Appendix C lists petrolatum, wiping rags and similar items which are used in repairing the
transmission. Expendable items are called out under SUPPLIES on initial setup pages in
maintenance procedures where reference is provided to the location of the expendable item in
Appendix C. For example, “(Item 8, Appendix C).”
ILLUSTRATED LIST OF MANUFACTURED ITEMS
Appendix D provides information for making locally fabricated items. These items are called
out on the initial setup pages of procedures under FABRICATED TOOLS where reference is
made to the appendix, such as “(Refer to Appendix D).”
This appendix contains procedures and illustrations to manufacture the required part. A
cross-reference is provided in the appendix to show the paragraph number and paragraph name
in the maintenance procedures where the tool will be used.
GLOSSARY
The glossary contains abbreviations, terms and definitions which may be unique to
transmissions Words or terms which are generally understood among maintenance personnel
are not listed in the glossary.
X
Back to Top
