TM-9-2520-272-34P

CROSS DRIVE TRANSMISSION WITH CONTAINER MODEL X200-4 & 4A

TECHNICAL MANUAL; INTERMEDIATE, DIRECT, AND GENERAL SUPPORT MAINTENANCE MANUAL (INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST)

TM-9-2520-272-34P - Page 247 of 488

TM 9-2520-272-34&P

4-28.

DISASSEMBLE CENTER HOUSING

(SHEET 10 OF 19)

TASK 5. REMOVE GOVERNOR ASSEMBLY, GOVERNOR BODY ASSEMBLY,

AND GOVERNOR DRIVE GEAR

TOOLS:

Extension, socket wrench, 1/2 inch square drive, 10 inch

Handle, socket wrench, 1/2 inch square drive

Socket, socket wrench, 1/2 inch square drive, 9/16 inch

Socket, socket wrench, 1/2 inch square drive, 1/2 inch

NOTE

Transmission is on maintenance stand, right end up.

1

2

3

Using 1/2 inch socket, remove four bolts (1) and

washers (2) that retain access cover (3) to center

housing.

Remove cover (3) and gasket (4).

Turn governor assembly (5) slightly to the left

(counterclockwise) and pull it from center housing.

4 Using 9/16 inch socket, remove three bolts (6) and

washers (7). Remove governor body assembly (8).

5 Remove governor drive gear (9).

FOLLOW-ON PROCEDURE:

Install governor drive

gear, governor body assembly, governor assembly,

and sleeve spacer. Refer to paragraph 4-30.

End of Task 5

Go to Sheet 11

Para. 4-28, Task 5

Change 1

4-181