TM-9-2520-272-40
CROSS-DRIVE TRANSMISSION WITH CONTAINER MODEL X200-4A
TECHNICAL MANUAL; SUSTAINMENT MAINTENANCE MANUAL
FEBRUARY 2012
TM-9-2520-272-40 - Page 35 of 620
TM 9-2520-272-40
0001
SHIPPING
NOTE
On early model transmission assemblies, the installation tag states to remove and discard six
nuts and six support brackets that secure the torque converter to the transmission assemblies
for shipment. This tag is in error. The six support brackets and six nuts must be retained.
However, only three brackets and three nuts need be installed for shipping.
Some later models of the transmission assemblies utilize three shipping brackets, three nuts,
three bolts, and 15 washers for retaining the torque converter for shipping.
Latest model transmission assemblies utilize three shipping brackets and three nuts for
retaining the torque converter for shipping. These brackets and nuts are identical to those used
on early six-bracket conf gurations.
Do not reuse nuts for transmission assembly installation. Use used nuts only for reinstallation
of shipping brackets.
All bolts, washers, nuts, and brackets will be stored with reusable shipping and storage
container for use when installing transmission assemblies in reusable shipping and storage
containers.
Dependent upon where transmission assembly in reusable shipping and storage container
originated from, shipping plugs and caps may or may not be present.
Field Maintenance personnel must ship unserviceable transmission assemblies and reusable shipping and storage
containers to Sustainment Maintenance.
Sustainment Maintenance personnel must ship unserviceable transmission assemblies and reusable shipping and
storage containers to Depot Maintenance. Sustainment Maintenance personnel may also return to supply or return
to unit repaired transmission assemblies as necessary.
Empty reusable shipping and storage containers are to be shipped or stored in accordance with local directives.
0001
‐
3
Back to Top
