TM-9-2520-272-40

CROSS-DRIVE TRANSMISSION WITH CONTAINER MODEL X200-4A

TECHNICAL MANUAL; SUSTAINMENT MAINTENANCE MANUAL

FEBRUARY 2012
TM-9-2520-272-40

  TM-9-2520-272-40 - Page 537 of 620

TM 9-2520-272-40
0067
MANDATORY REPLACEMENT PARTS
Replace parts that may be deformed during use or damaged during removal. SUCH ITEMS SHOULD BE
DISCARDED WHEN THEY ARE REMOVED. Replacement items used in reassembly must be new.
Parts listed in Table 1 will be replaced each time they are removed in transmission disassembly:
Table
1.
Mandatory Replacement Parts.
Gaskets
Oil seals
Locknuts
O-rings
Lockstrips
Preformed packings
Lockwashers
Tab washers
Mandatory Replacement Parts in Event of Metal Contamination
In addition to standard replacement parts listed in Table 1, the following MINIMUM repair and replacement must be
performed in all cases of metal contamination:
1. Replace the hydrostatic pump and motor.
2. Replace the control valve assemblies.
3. Replace the bevel gear assembly, including oil pumps.
4. CLEAN AND INSPECT ALL PARTS. Replace parts as necessary.
END OF TASK
PARTS REQUIREMENTS FOR EQUIPMENT CONDITIONS
1. The headings of maintenance tasks contain lists of Equipment Conditions. The Equipment Conditions category
provides names and locations of other procedures to be completed before you can start work on your assigned
task.
2. When Equipment Conditions are needed only to gain access to a work area, examine the items in
Materials/Parts category of the initial setup. Select only the supplies and parts needed to complete your
work requirement.
END OF TASK
LOCALLY FABRICATED SHOP AIDS
When a maintenance task includes an item to be fabricated, the item is listed under the heading Tools and
Special Tools. These fabricated shop aids are listed in Illustrated List of Manufactured Items, WP 0075, including
instructions for manufacturing the item.
END OF TASK
REPAIR PARTS
Repair parts are listed and illustrated in TM 9-2520-272-40P, Repair Parts and Special Tools List for Cross-Drive
Transmission with Container, Model X200-4A.
END OF TASK
0067
‐
9


Back to Top