TM-9-2520-272-40
CROSS-DRIVE TRANSMISSION WITH CONTAINER MODEL X200-4A
TECHNICAL MANUAL; SUSTAINMENT MAINTENANCE MANUAL
FEBRUARY 2012
TM-9-2520-272-40 - Page 535 of 620
TM 9-2520-272-40
0067
Springs
Look at springs for wear or breaks. If bad, discard springs.
Retaining Rings (Snap Rings)
Look at retaining rings for cracks, bends, burrs, or nicks. Remove burrs and nicks with whetstone. If rings are
cracked or bent, discard rings. Snap rings must be tight in grooves.
Threaded Parts
1. Inspect all threaded parts for stripped or damaged threads and burrs.
2. Replace all parts that have stripped threads or have damage which cannot be repaired by chasing the threads
with a tap or die of the proper size, or by installing threaded inserts.
END OF TASK
LUBRICATION
1. Refer to Vehicle Lubrication Order LO 9-2350-277-13 (M113) for general lubrication information for the
transmission.
2. When repairing, assembling, or installing transmission components, make sure all moving parts are well oiled
with lubricating oil. This oil will protect parts during the f rst few moments after engine start-up.
3. Put lubricating oil on all moving parts, such as gears, shafts, and bearings. Also put oil on mating surfaces
of valve bodies and housings that mate with moving parts. Put oil or petrolatum on all preformed packings,
O-rings, seals, and seal rings as required in the task. Put oil on parts with hand oiler or dip parts in a container
of clean oil.
4. Put high-temperature grease on the inside lip of all plain encased seals.
5. Use petrolatum when required to hold gaskets, thrust washers, bushings, or other parts in place during
assembly.
6. The combined application of petrolatum and lubrication oil on journals makes bearings or races slide on
and off the journals more easily.
7. Immerse all plates in clean lubricating oil one at a time before assembly. Keep all plates in the same order and
facing the same way as when disassembled. Soak plates for a minimum of two minutes.
8. Soak each new friction-faced friction plate for a minimum of two minutes in clean lubricating oil.
9. Put lubricating oil on walls and hubs that seal rings will contact.
NOTE
New plugs with pre-coated threads, such as Tef on-coated threads, need no lubrication or
sealant before they are installed.
10.Put a small amount of nonhardening sealing compound on the f rst three threads of all reused or uncoated
external pipe plugs and hydraulic f ttings.
END OF TASK
0067
‐
7
Back to Top
