TM-9-2815-202-34

TM 9-2815-202-34

APPENDIX D lists manufactured items that are used to support the procedures.

APPENDIX E gives the general torque limits required for standard fasteners on the engine.

APPENDIX F lists the mandatory replacement parts used to maintain or repair the engine.

APPENDIX G lists the engine repair specifications for repairing the engine.

GLOSSARY gives the meaning of unusual terms found in the procedures.

ALPHABETICAL INDEX lists the major engine parts that can be repaired or replaced at the DS

or GS level. Each entry in the index includes the procedure paragraph number.

DA FORM 2028-2

is used to report an error found in this manual.

METRIC CONVERSION CHART converts U.S. measurements to their metric equivalents.

Measurements in the procedures are given in both U.S. and metric units.

HOW TO USE YOUR MANUAL ON THE JOB

The best way to Iearn about this manual is to practice using it. Knowing how to use this

manual will save time and effort.

Where do you start?

Entry to a repair procedure in this manual may come from observation, troubleshooting, or the

Army Oil Analysis Program (AOAP). The problem will help identify the item that needs repair or

replacement.

How do you fix the problem?

Find the correct repair procedure in the manual. Pick a key word from the item to be

repaired or replaced. Look up the word in the Alphabetical Index, which gives the

paragraph number of the procedure.

Turn to the procedure and read it carefully before starting. Pay attention to warnings

and cautions. Get the equipment, supplies, and any other personnel needed. Parts

which will be destroyed or should not be reused are listed in the setup as Mandatory

Replacement Parts.

Start with step a in the procedure and do each step in order. In some referenced

procedures, one or more steps may have been completed. If so, proceed to the next

step. If a part fails inspection and requires replacement, refer to the Repair Parts and

Special Tools List (RPSTL) TM 9-2815-202-24P.

Change 1

TM-9-2815-202-34 - Page 18 of 670