TM-9-2815-205-24

6V53/6V53T ENGINES, DIESEL WITH CONTAINERS; MODEL 5063-5299, MODEL 5063-5392, MODEL 5063-5393 AND MODEL 5063-539L

TECHNICAL MANUAL; FIELD AND SUSTAINMENT MAINTENANCE

FEBRUARY 2013
TM-9-2815-205-24

  TM-9-2815-205-24 - Page 169 of 856

INSTALLATION - Continued
NOTE
Center bolt (Figure 5, Item 13) is installed through clip (Figure 5, Item 10) into oil cooler
assembly (Figure 5, Item 9).
6.
Loosely install three flat washers (Figure 5, Item 11), three new lockwashers (Figure 5, Item 12), and three
bolts (Figure 5, Item 13) on oil cooler assembly (Figure 5, Item 9). Remove two oil cooler studs
(Figure 4, Item 40).
7.
Install transmission oil cooler bracket (Figure 5, Item 14), five flat washers (Figure 5, Item 17), five new
lockwashers (Figure 5, Item 16), and five bolts (Figure 5, Item 15) on oil cooler assembly (Figure 5, Item 9).
8.
Install bracket (Figure 5, Item 21), two flat washers (Figure 5, Item 20), two new lockwashers
(Figure 5, Item 19), and two bolts (Figure 5, Item 18) on transmission oil cooler bracket (Figure 5, Item 14).
9.
Torque two bolts (Figure 5, Item 18), five bolts (Figure 5, Item 15), and three bolts (Figure 5, Item 13) to
13–17 lb-ft (18–23 N·m).
10.
Slide hose (Figure 5, Item 7) and two clamps (Figure 5, Item 8) onto oil cooler assembly (Figure 5, Item 9).
11.
If removed, install pipe plug (Figure 5, Item 4) in elbow (Figure 5, Item 5).
12.
Insert elbow (Figure 5, Item 5) into hose (Figure 5, Item 7) and install new gasket (Figure 5, Item 6), elbow
(Figure 5, Item 5), two new lockwashers (Figure 5, Item 2), and two bolts (Figure 5, Item 1) on cylinder
block. On model 5063-5393, the front (left) bolt goes through clip (Figure 5, Item 3) on hose
(Figure 5, Item 40). Torque bolts to 13–17 lb-ft (18–23 N·m).
13.
Adjust hose (Figure 5, Item 7) and two clamps (Figure 5, Item 8) between elbow (Figure 5, Item 5) and oil
cooler assembly (Figure 5, Item 9) with clamp adjusting screws facing front of engine. Tighten clamps
securely.
MAINT_067
15
16
17
18
19
20
21
14
1
2
3
40
4
5
6
7
8
9
10
11
12
13
Figure 5.
Engine Oil Cooler Hardware Installation.
END OF TASK
TM 9-2815-205-24
0022
0022-7


Back to Top