TM-9-2815-205-24
6V53/6V53T ENGINES, DIESEL WITH CONTAINERS; MODEL 5063-5299, MODEL 5063-5392, MODEL 5063-5393 AND MODEL 5063-539L
TECHNICAL MANUAL; FIELD AND SUSTAINMENT MAINTENANCE
FEBRUARY 2013
TM-9-2815-205-24 - Page 159 of 856
INSTALLATION
1.
Install new gasket (Figure 6, Item 30), oil cooler adaptor (Figure 6, Item 29), two flat washers
(Figure 6, Item 21), two new lockwashers (Figure 6, Item 22), two large screws (Figure 6, Item 23), flat
washer (Figure 6, Item 24), new lockwasher (Figure 6, Item 25), and small bolt (Figure 6, Item 26) on
cylinder block.
2.
Torque two screws (Figure 6, Item 23) to 30–35 lb-ft (41–47 N·m) and bolt (Figure 6, Item 26) to 13–17 lb-ft
(18–23 N·m).
3.
Install two studs (Figure 6, Item 28) in positions (Figure 5, Item A) and (Figure 5, Item B) to act as guides.
4.
Position new gasket (Figure 6, Item 18), oil cooler element (Figure 6, Item 19), and new gasket
(Figure 6, Item 20) on two studs (Figure 6, Item 28) with port marked "IN" toward front of engine and slide
gaskets (Figure 6, Items 18 and 20) and element (Figure 6, Item 19) up against oil cooler adaptor
(Figure 6, Item 29).
5.
Position oil cooler assembly (Figure 6, Item 12) on two studs (Figure 6, Item 28) and slide up against oil
cooler adaptor (Figure 6, Item 29).
18
19
20
12
23
22
21
24
25
26
27
28
29
30
MAINT_057A
Figure 6.
Engine/Transmission Oil Cooler Installation.
TM 9-2815-205-24
0021
0021-9
Back to Top
