TM-9-2815-205-24

6V53/6V53T ENGINES, DIESEL WITH CONTAINERS; MODEL 5063-5299, MODEL 5063-5392, MODEL 5063-5393 AND MODEL 5063-539L

TECHNICAL MANUAL; FIELD AND SUSTAINMENT MAINTENANCE

FEBRUARY 2013

TM-9-2815-205-24 - Page 156 of 856

CLEANING - Continued

WARNING

Cleaning solvent is TOXIC and flammable. Wear protective goggles and gloves; use only

in a well-ventilated area; avoid contact with skin, eyes, and clothes; and do not breathe

vapors. Keep away from heat or flame. Never smoke when using cleaning solvent. Failure

to comply may result in injury, illness, or death to personnel.

8.

Clean oil cooler housing and cover with cleaning solvent and dry with compressed air.

END OF TASK

TEST AND INSPECTION

WARNING

Protect personnel against any stream of pressurized water from a leak or rupture of a

fitting, hose, or oil cooler during high-pressure air-leak test. Failure to comply may result in

injury to personnel.

1.

Install rubber gasket (Figure 4, Item 42), fabricated blocking plate (Figure 4, Item 41), 10-5/16 inch diameter

screws (Figure 4, Item 45), flat washers (Figure 4, Item 44), and nuts (Figure 4, Item 43) from pressure

testing kit (WP 0081, Figure 6) on transmission oil cooler (Figure 4, Item 33) or engine oil cooler

(Figure 4, Item 19).

2.

Connect air line to blocking plate (Figure 4, Item 41) and apply pressure of 75 PSI (517 kPa) to oil cooler.

TM 9-2815-205-24

0021

0021-6