TM-9-2815-205-24
6V53/6V53T ENGINES, DIESEL WITH CONTAINERS; MODEL 5063-5299, MODEL 5063-5392, MODEL 5063-5393 AND MODEL 5063-539L
TECHNICAL MANUAL; FIELD AND SUSTAINMENT MAINTENANCE
FEBRUARY 2013
TM-9-2815-205-24 - Page 185 of 856
INSTALLATION
1.
Connect hose assembly (Figure 1, Item 1) to connector (Figure 1, Item 2) in top of turbocharger
(Figure 1, Item 3). Tighten securely.
2.
Connect hose assembly (Figure 1, Item 1) to oil filter adaptor (Figure 1, Item 6). Refer to (WP 0018) for
model 5063-5392 or (WP 0019) for models 5063-5393 and 5063-539L.
3.
Remove screw (Figure 1, Item 5) and lockwasher (Figure 1, Item 4) from plate (Figure 1, Item 8) at rear of
left cylinder head and install screw (Figure 1, Item 5) and new lockwasher (Figure 1, Item 4) in clip
(Figure 1, Item 7) and plate (Figure 1, Item 8). Torque screw to 30–35 lb-ft (41–47 N·m).
4.
For model 5063-5392: If removed, install clip (Figure 1, Item 13) on hose assembly (Figure 1, Item 1). Install
screw (Figure 1, Item 12), flat washer (Figure 1, Item 16), new lockwasher (Figure 1, Item 15), and nut
(Figure 1, Item 14) in clip on hose assembly and in bracket (Figure 1, Item 17) on air inlet housing. Torque
screw to 30–35 lb-ft (41–47 N·m).
5.
For models 5063-5393 and 5063-539L: If removed, install clip (Figure 1, Item 9) on hose assembly
(Figure 1, Item 1). Remove screw (Figure 1, Item 11) and new lockwasher (Figure 1, Item 10) located at left
side of flywheel housing. Install screw (in clip on hose assembly) and new lockwasher on flywheel housing.
Torque screw to 30–35 lb-ft (41–47 N·m).
END OF TASK
END OF WORK PACKAGE
TM 9-2815-205-24
0025
0025-3/blank
Back to Top
