TM-9-2815-205-24
6V53/6V53T ENGINES, DIESEL WITH CONTAINERS; MODEL 5063-5299, MODEL 5063-5392, MODEL 5063-5393 AND MODEL 5063-539L
TECHNICAL MANUAL; FIELD AND SUSTAINMENT MAINTENANCE
FEBRUARY 2013
TM-9-2815-205-24 - Page 825 of 856
FIELD MAINTENANCE
ENGINE REPAIR SPECIFICATIONS
INTRODUCTION
Scope
This appendix lists the repair specifications for the 6V53/6V53T Diesel Engines. Refer to Table 1.
Explanation of Columns for the Repair Specifications List
Column 1 - Point of Measurement - This column lists the area of the engine (e.g., CYLINDER BLOCK), then lists
the specific component (e.g., Main Bearing Bore), and finally describes the critical dimension (e.g., Inside
diameter).
Column 2 - New Minimum - This column lists the minimum acceptable dimension of the new part. All dimensions
are in inches unless stated differently.
Column 3 - New Maximum -This column lists the maximum acceptable dimension of the new part. All dimensions
are in inches unless stated differently.
Column 4 - Wear Limit - This column lists the maximum acceptable deviation for the used part. All dimensions are
in inches unless stated differently. An asterisk (*) in this column indicates the part must keep the same minimum
and maximum limit as the new part.
Table 1.
Repair Specifications List.
(1) POINT OF
MEASUREMENT
(2) NEW MINIMUM
INCHES (MM)
(3) NEW MAXMUM
INCHES (MM)
(4) WEAR LIMIT
INCHES (MM)
CYLINDER BLOCK
Diameter (top)
4.5195 (114.80)
4.5215 (114.85)
4.5235 (114.90)
Diameter (center)
4.4865 (113.96)
4.488 (114.00)
4.4900 (114.05)
Diameter (bottom)
4.3565 (110.66)
4.3575 (110.68)
4.3595 (110.73)
Out–of–round
0.0015 (0.04)
0.0020 (0.05)
*
Taper
0.0015 (0.04)
0.0020 (0.05)
Cylinder Liner Counterbore
Diameter
4.8200 (122.43)
4.8350 (122.81)
*
Depth
0.3000 (7.62)
0.3020 (7.67)
*
Main Bearing Bore
Inside diameter (vertical
axis)
3.7510 (95.28)
3.7520 (95.30)
*
TM 9-2815-205-24
0106
0106-1
Back to Top
