TM-9-2815-205-34
ENGINE WITH CONTAINER; MODELS 5063-5299, 5063-5392, 5063-5393, 5063-5395, 5063-5398, 5063-539F, 5063-539L
TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE
AUGUST 1992
TM-9-2815-205-34 - Page 20 of 596
TM 9-2815-205-34
1-8. LOCATION AND DESCRIPTION OF COMPONENTS (Cont)
h.
i.
j.
k.
l.
m.
n.
o.
p.
q.
r.
Oil Filter (8).
Mounted on the lower left side of
engine block for all except model 5063-5392.
Model 5063-5392 has it mounted near the left
rear cylinder head. It filters the engine lubrica-
tion oil.
Governor (9).
Mounted on the rear end of the
blower and driven from a blower drive gear. It
is used to control the idle and maximum engine
operating speeds.
Oil Pan (10).
Mounted on the bottom of the
cylinder block. It provides a reservoir for en-
gine oil.
Starter (11).
Mounted on right side of flywheel
housing. It is an electric starter and engages
the flywheel ring gear.
Flywheel (12).
Mounted on the rear of the
crankshaft. It is used to provide true alinement
of transmission flex plate.
Fuel Strainer (13).
On model 5063-5299, it is
remote mounted. On model 5063-5392, it is
mounted near the left rear corner of the en-
gine. On models 5063-5393 and 5063-539L, it
is mounted on the lower right side. On models
5063-5395, 5063-5398, and 5063-539F, it is
mounted near the right rear corner of the en-
gine. It filters fuel to fuel pump.
Fuel Filter (14).
Mounted adjacent to the fuel
strainer. It filters fuel to fuel inlet manifold.
Turbocharger (15).
Mounted on the rear of the
engine (models 5063-5393, 5063-5395,
5063-5398, 5063-539F, and 5063-539L) or on
the blower (model 5063-5392). It increases en-
gine power by delivering high pressure air to
the blower using exhaust gas energy. Model
5063-5299 has no turbocharger.
Fuel Pump (16).
Attached to the flywheel
housing and driven off the right side camshaft
gear. It supplies low pressure fuel to fuel inlet
manifolds in cylinder heads.
Blower (17).
Mounted on top of the cylinder
block. It supplies a constant volume of fresh air
per revolution to the cylinders.
Cylinder Heads (18).
Mounted on top of each
cylinder bank. They contain fuel manifolds, ex-
haust valves, injectors, and injector and valve
operating mechanisms.
1-8
Change 1
Back to Top
