TM-9-2815-210-34-2-1
ENGINE ASSEMBLY, DIESEL (MULTIFUEL): NATURALLY ASPIRATED OR TURBOCHARGED, FUEL-INJECTED, WATER-COOLED, 6-CYLINDER
TECHNICAL MANUAL; TROUBLESHOOTING; DIRECT SUPPORT AND GENERAL SUPPORT LEVEL; VOLUME 2 OF 2; PART 1 OF 2
APRIL 1981
TM-9-2815-210-34-2-1 - Page 77 of 259
TM 9-2815-210-34-2-1
3-8. FUEL INJECTOR TUBES.
a.
Tube Clamps.
(1) All engines except LDS-465-2.
FRAME
1
1.
2.
3.
4.
5.
6.
NOTE
Some engines have six tube clamps (2) and some have
two tube clamps.
Procedure shown is for engines
with six clamps.
Take out four screws and locknuts (1) and take off four tube clamps (2).
Take out two screws, four flat washers, and two locknuts (3) and take off
outer half of tube clamp (4).
Take off nut, lockwasher, and flat washer (5) and take off inner half of tube
clamp (4).
Take out two screws, flat washers, and locknuts (6) and take off tube clamp
(7) .
NOTE
Some engines do not have bracket (9).
Take out screw (8) and take off bracket (9).
NOTE
Some engines do not have lockbolts (10).
Take out two lockbolts (10).
END OF TASK
3-29
Back to Top
