TM-9-2815-220-24

AVDS-1790 2CA, 2DA and 2DR Air-Cooled 12-Cylinder Diesel Engines

TECHNICAL MANUAL; UNIT, DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE MANUAL FOR AVDS-1790 2CA, 2DA and 2DR Air-Cooled 12-Cylinder Diesel Engines

  TM-9-2815-220-24 - Page 1024 of 1563

TM 9-2815-220-24
THROTTLE/GOVERNOR (ADJUSTABLE) CONTROL ROD REPAIR
0125 00
INSPECTION (Continued)
2. Measure the clearance (A) between ball and socket (endplay) of two rod end/bearings (1, 2) at
ends of governor control rod (3) using a dial indicator (item 65, WP 0176).
Replace rod
end/bearing if not within the following limits.
Location
Sizes and Fits of New Parts inches (mm)
Wear Limits
A
(Bearing endplay)
0.0005 (0.0127)
0.0015 (0.0381)
0.0020 (0.0508)
2
3
1
A
REPAIR
NOTE
Either rod end/bearing (1 or 2) can be repaired in the same manner,
only one end is described.
One end is right-hand thread, and the
opposite end is left-hand thread.
1. Remove rod end/bearing (1 or 2) from control rod (3) by loosening nut (4 or 5) and then
turning rod end/bearing.
2. Install new rod end/bearing (1 or 2), then set length to approximately 10.92 inches
(277.3680 mm) and tighten nut (4, 5).
3
4
1
5
2
END OF WORK PACKAGE
WP 0125 00-2


Back to Top