TM9-2815-224-34&P
CHAPTER 6
PISTON AND CONNECTING ROD MAINTENANCE
Contents
Para
General . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6-1
Piston, Connecting Rod and Liner Removal/Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6-2
Piston Repair . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6-3
Section 1.
INTRODUCTION
Page
6-1
6-1
6-7
6-1.
GENERAL. This chapter
covers removal and installation of the piston and connecting rod
assemblies. The subassemblies and parts which must be removed before the piston and connecting rod can
be removed will be referenced to other paragraphs chapter of this manual, TM 9-2320-279-10,
TM 9-2320-279-20, or TM 9-2320-279-34.
Section Il.
PISTON AND CONNECTING ROD
Piston and Connecting Rod Maintenance Instructions
6-2.
PISTON, CONNECTING ROD, AND LINER REMOVAL/INSTALLATION.
This
task covers:
a. Removal
c. Follow-on Maintenance
b. Installation
INITIAL SETUP
Models
Equipment Condition
All
TM or Para
Condition Description
Test Equipment
TM 9-2320-279-34 Engine installed on engine
None
stand.
Special Tools
Para 8-3
Oil pan removed.
Para 8-4
Oil pump removed.
Remover assembly, cylinder liner J24563-A
Para 3-7
Cylinder head removed.
Clamp, cylinder liner J24565-02
Special Environmental Conditions
Supplies
None
Oil, lubricating, Item 48, Appendix C
Tags, identification, Item 61, Appendix C
General Safety Instructions
None
Personnel Required
MOS 63W, Wheel vehicle repairer (2)
Level
of Maintenance
General Support
References
None
6-1