TM-9-2815-224-34-P
ENGINE, DIESEL:8-CYLINDER TURBOCHARGED, DETROIT DIESEL CORPORATION MODEL 8V92TA
DIRECT SUPPORT AND GENERAL SUPPORT MAINTENACE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST
JANUARY 1988
TM-9-2815-224-34-P - Page 86 of 554
TM 9-2815-224-34&P
Cylinder Head Maintenance Instructions
3-7. CYLINDER HEAD REMOVAL/INSTALLATION (CONT).
NOTE
Compression gaskets are color coded. Be sure
to note color for replacement.
(17)
Remove seal strip gasket (32), two
support shims (33), seventeen water
seals (34), oil seal (35), and four
compression gaskets (36).
(18)
Remove gasket (37) from crossover
tube (13).
b. Cleaning and Inspection.
WARNING
Adhesives, solvents, and sealing compounds
can burn easily, can give off harmful vapors
and are harmful to skin and clothing. To
avoid injury or death, keep away from open
fire and use in well-ventilated area. If
adhesive, solvent, or sealing compound gets
on skin or clothing, wash immediately with
soap and water.
(1)
Clean cylinder head (1) with
drycleaning solvent.
WARNING
Compressed air used for cleaning purposes will not exceed 30 psi. Use only with
effective chip guarding and personal protective equipment (goggles/shield, gloves,
etc.)
(2)
Dry cylinder head (1) with compressed air.
(3)
Inspect cylinder head mounting surface to be sure it is clean and free from burrs.
3-38
Change 2
Back to Top
