TM-9-2815-224-34-P
ENGINE, DIESEL:8-CYLINDER TURBOCHARGED, DETROIT DIESEL CORPORATION MODEL 8V92TA
DIRECT SUPPORT AND GENERAL SUPPORT MAINTENACE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST
JANUARY 1988
TM-9-2815-224-34-P - Page 95 of 554
TM 9-2815-224-34&P
Cylinder Head Maintenance Instructions (Cont)
(13)
Remove nine pipe plugs (3.5)
from cylinder head (3).
b. Cleaning/Inspection.
WARNING
(1)
(2)
(3)
(4)
(5)
(5)
Adhesives, solvents, and sealing compounds can burn easily, can give off harmful
vapors, and are harmful to skin and clothing. To avoid injury or death, keep away
from open fire and use in well-ventilated area. If adhesive, solvent, or sealing
compound gets on skin or clothing, wash immediately with soap and water.
Clean stripped cylinder head wash dry cleaning solvent.
WARNING
Compressed air used for cleaning purposes will not exceed 30 psi (207 kPa). Use
only with effective chip guarding and personal protective equipment
(goggles/shield, gloves, etc.).
Dry cylinder head with compressed air.
Aline straightedge along
1
2
3
4
5
lines 1, 2, 3, 4, and 5 on
cylinder head (1). Measure for
warp with feeler gage at
points where lines 6, 7, 8, 9,
10, and 11 intersect
straightedge.
If warp measurement exceeds
0.004-in. (0.1 mm), cylinder
head (1) must be replaced.
Aline straight edge along
lines 6, 7, 8, 9, 10, and 11 on
cylinder head (1). Measure al
points where lines 1, 2, 3, 4.
and 5 intersect straightedge.
If warp measurement exceeds 0.008-in. (0.2 mm), cylinder head (1) must be replaced.
3-47
Back to Top
