TM-9-2815-225-34-P

ENGINE, DIESEL: 6 CYLINDER IN-LINE TURBOCHARGED, CUMMINS MODEL NTC-400

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST

JULY 2005
TM-9-2815-225-34-P

  TM-9-2815-225-34-P - Page 49 of 736

TM 9-2815-225-34&P
0005 00
0005 00-1
DIRECT SUPPORT AND GENERAL SUPPORT
MAINTENANCE MANUAL
INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST (RPSTL)
FOR
M915, M915A1, M915A4, M916, M920 VEHICLES
P/N NTC400-3652-02
CUMMINS NTC-400 BIG CAM I DIESEL ENGINE
W/CONTAINER
P/N 11669835
CUMMINS NTC-400 BIG CAM III DIESEL ENGINE
W/CONTAINER
PREVENTIVE MAINTENANCE CHECKS AND SERVICES (PMCS) INTRODUCTION
SCOPE
This Work Package (WP) explains the content and format of the Unit Level PMCS Instructions table
contained in WP 0006 00. Also included in this WP are PMCS and lubrication guidelines that should be
reviewed before performing any PMCS procedures.
EXPLANATION OF PMCS TABLE
Item Number Column.
Numbers in this column are for reference. When completing DA Form 2404
(Equipment Inspection and Maintenance Worksheet), include the item number for the check/service
indicating a fault. Item numbers also indicate the order in which
you must perform checks and services
for the interval listed.
Interval Column.
This column tells you when you must perform each procedure in each Procedure
column.
Before—procedures must be done immediately before you operate the vehicle.
During—procedures must be done while you are operating the vehicle.
After—procedures must be done immediately after you have operated the vehicle.
Weekly—procedures must be done once each week.
Monthly—procedures must be done once each month.
Item to Inspect/Service Column.
This column provides the location and item to be checked or
serviced and manhours to complete task.
Procedure Column.
This column identifies the procedure you must perform to check or service the
item listed in the Item to Inspect/Service column. You must perform the procedure at the time stated in
the interval column.
Equipment Not Ready/Available If: Column.
Information in this column tells you what faults keep
your equipment from being capable of performing its primary mission. If checks or service procedures
show faults listed in this column, the equipment is not mission-capable. Follow standard operating
procedures for maintaining the equipment or reporting equipment failure.


Back to Top