TM-9-2815-225-34-P
ENGINE, DIESEL: 6 CYLINDER IN-LINE TURBOCHARGED, CUMMINS MODEL NTC-400
TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST
JULY 2005
TM-9-2815-225-34-P - Page 51 of 736
TM 9-2815-225-34&P
0005 00
PREVENTIVE MAINTENANCE CHECKS AND SERVICES (PMCS) INTRODUCTION (Contd)
0005 00-3/4 blank
LUBRICATION GUIDELINES
1.
These instructions are mandatory.
2.
This equipment is enrolled in the Army Oil Analysis Program (AOAP). Engine oil and
transmission oil must be sampled every 90 days as prescribed by DA PAM 738-750.
3.
Engines must receive lubrication with approved lubricants at recommended intervals in order to
be mission-ready at all times.
4.
Recommended intervals are based on normal conditions of operation, temperature, and humidity.
When operating under extreme conditions, lubricants should be changed more frequently. When
in doubt, notify your supervisor.
SPECIFIC LUBRICATION INSTRUCTIONS
1.
Keep all lubricants in a closed container and store in a clean, dry place away from extreme heat.
Keep container covers clean and do not allow dust, dirt, or other foreign material to mix with
lubricants. Keep lubrication equipment clean and ready for use.
2.
Maintain a record of lubrication performed and report any problems noted during lubrication.
Refer to DA PAM 738-750 for maintenance forms and procedures to record and report any
findings.
3.
Keep all external parts of equipment not requiring lubrication free of lubricants. After lubrication,
wipe off excess lubricant to prevent accumulation of foreign matter.
4.
Refer to FM 9-207 for lubrication instructions in cold weather.
END OF WORK PACKAGE
Back to Top
