TM-9-2920-225-34
GENERATOR ASSEMBLY; PRESTOLITE AMA-5102UT; LEECE-NEVILLE 3002AC, 3002AD, 3002AE, 5504AA, 5504AB, 2184AC, 5300GP
TECHNICAL MANUAL; MAINTENANCE; DIRECT AND GENERAL SUPPORT LEVEL
FEBRUARY 1981
TM-9-2920-225-34 - Page 51 of 262
TM 9-2920-225-34
FRAME 2
I
1.
2.
3*
4.
5.
Place a piece of l/8-inch thick felt over fan of rotor and fan assembly (1).
Place stator (2) over rotor and fan assembly (1) with stator leads facing fan.
Place drive end housing (3) up to stator (2).
NOTE
Have machine shop make fabricated tool. Refer to
figure 2-2.
Put rotor assembly tool over threaded end of shaft so that large end of tool
is against shaft shoulder. Coat shaft journal and inside diameter of lip
seal (4) with grease. Place lip seal over tool and onto shaft and take off
tool
●
With sharp edge of inner race of bearing (5) facing away from rotor (1),
press bearing onto shaft of rotor and fan assembly.
GO TO FRAME 3
TA103537
2-35
Back to Top
