TM-9-2920-225-34
GENERATOR ASSEMBLY; PRESTOLITE AMA-5102UT; LEECE-NEVILLE 3002AC, 3002AD, 3002AE, 5504AA, 5504AB, 2184AC, 5300GP
TECHNICAL MANUAL; MAINTENANCE; DIRECT AND GENERAL SUPPORT LEVEL
FEBRUARY 1981
TM-9-2920-225-34 - Page 65 of 262
TM 9-2920-225-34
2-9. END HOUSING AND ROTOR ASSEMBLY .
TOOLS: No special tools required
SUPPLIES : End housing preformed packing
Lip seal (2)
Sleeve seal
Ball bearing and roller bearing grease, MIL-G-18709
PERSONNEL: One
EQUIPMENT CONDITION :
Generator removed from vehicle, pulley removed from
generator.
a.
Preliminary Procedures.
(1) Clean generator before disassembly. Refer to para 1-3.
(2) Remove drive end bell and regulator assembly. Refer to para 2-8.
(3) Remove fan and hub assembly. Refer to para 2-7.
.
Removal.
FRAME 1
1.
Take out six screws (1) .
NOTE
Scribe a mark from end housing (2) to intermediate
housing (3) so that housings can be put back the
same way.
2.
Take end housing (2) and rotor (4) assembly out of intermediate housing ( 3).
NOTE
When rotor (4) is taken out, brushes will fall out
at drive end of intermediate housing (3). Take
out brushes.
END OF TASK
TA103550
2-49
Back to Top
