TM-9-3990-260-14-P

CONTAINER ROLL-IN/OUT PLATFORM (CROP) MODEL M3 AND MODEL M3A1

TECHNICAL MANUAL; OPERATOR’S, UNIT, DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE MANUAL (INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST)

JULY 2001

  TM-9-3990-260-14-P - Page 204 of 306

TM 9-3990-260-14&P
9-19. BUMPER REPLACEMENT.
This task covers:
a. Removal
b. Installation
c. Follow-on Maintenance
INITIAL SETUP
Tools and Special Tools
Material and Parts
Tool Kit, General Mechanic's: Automotive
Lock Washer (2 ea), Appendix H, Table H-2,
(Item 5, Appendix I).
Item 4.
a.
Removal.
NOTE
This procedure shows replacement of one bumper. Replacement is the same for the
other bumper.
It is necessary to hold bumper nut (1) while turning socket head screws with a 3/8-
inch hex key while loosening nuts (1).
(1)
Remove two nuts (1), lock washers (2), flat washers (3) and socket head screws (4) from
bumper (5). Discard lock washers.
(2)
Remove bumper (5) from end rail (6).
b.
Installation.
(1)
Position bumper (5) to end rail (6).
(2)
Install two socket head screws (4), flat washers (3), lock washers (2) and nuts (1).
c.
Follow-on Maintenance.
None.
9-26


Back to Top