TM-9-6675-262-10
AIMING CIRCLE M2 W/E AND M2A2 W/E
TECHNICAL MANUAL; OPERATOR MANUAL
DECEMBER 2013
TM-9-6675-262-10 - Page 36 of 68
0005-4
INSTALLING THE AIMING CIRCLE ON TRIPOD
1.
Unscrew the screw assembly (Figure 4, Item 1) and remove tripod cover
assembly (Figure 4, Item 2) from tripod head (Figure 4, Item 3).
2.
Center screw assembly (Figure 5, Item 1) as shown below.
3.
Open base plate cover (Figure 5, Item 2) and place Aiming Circle on
tripod head (Figure 5, Item 6).
NOTE
Before tightening screw assembly, position base plate cover so it is
pointing toward you.
4.
Turn screw assembly (Figure 5, Item 1) into threaded hole on Aiming
Circle until screw is snug.
5.
Release catch assemblies (Figure 5, Item 3) and remove cover (Figure
5, Item 4) from Aiming Circle.
Hang Aiming Circle cover on the tripod
cover assembly (Figure 5, item 5).
Back to Top
