PS Magazine - TB 43-PS-564

PS, The Preventative Maintenance Monthly

ISSUE 564

NOVEMBER 1999

PS Magazine - TB 43-PS-564 - Page 11 of 34
here may not be any tires on the SUSV, mechanics, but you still need an air
pressure gauge to keep the steering damper in good working order.
The SUSV manual, TM 9-2350-285-20, calls for a 29–102 psi range of air
pressure in the damper accumulator. But that range is too wide.
A better range is between 55–
85 psi. Air pressure of at least 55
psi in the accumulator will pre-
vent damper bottoming, which
causes steering component dam-
age and rough handling. More
than 85 psi can overstress seals
and steering lines. Table 2-5 on
Page 2-10 of the TM will be up-
dated with this info at the next
change or revision.
If drivers complain that the SUSV rides or steers hard, and you find the air
pressure is between 55–85 psi, check out the accumulator hydraulic fluid level.
That information is found in Para 8-11 on Page 8-28 of TM 9-2350-285-20.
echanics, when you send a Stewart-Warner heater with a bad burner to DS
for repair, you don’t want to pay for a new burner, do you?
Since the burner repair kit, NSN
2540-00-255-0777, was left out of TM
9-2540-205-24&P, chances are support
will replace—not repair—the burner.
Let DS know the repair kit is still
available and that it works with
Stewart-Warner models 10560C,
10560G, 10560M and 10560M24B1.
Here’s what’s in the kit:
Personnel Heaters . . .
Small Unit Support Vehicle . . .
man,
this vehicle
sure rides
rough
!
yeah,
it's
not
supposed
to!
here's
what's in
the
kit
.
Check damper accumulator air pressure here
* Order on a DD Form 1348-6 using part
number and CAGE 38385 from RIC AKZ.
** Available only by ordering the burner
repair kit.
Item
PN/NSN
Qty
Nut, hex
705587*
3
castellated
Wick
1
Washer
2
Washer
705136*
2
Washer,
1
shouldered
Vaporizer,
1
fuel
Washer
1
Washer,
1
flat
Shield, fuel
1
vaporizer
Screw,
1
machine
Screw
3
19
NOV 99
PS 564
18
NOV 99


Back to Top
Back to Top