DMWR-9-2815-220
AVDS-1790 ENGINE OVERHAUL STANDARD
DEPOT MAINTENANCE WORK REQUIREMENT
DMWR-9-2815-220 - Page 470 of 1422
'·
DMR 9·285·220
5-53.
(Cont)
5
After truing alL beaRiNg joURna±s, Recheck camshaFts as out²i³ed in
pro´edure (aµ above.
I¶ Readings do not Meet di·ensions specified¸
Repeat tRUiNg oPeratioN.
¹cº
INspectioN of ca»shaft afte¼ stRaighteNiNg½
1
¾agnaF²ux e¿ch ca·shaFt and iNspect foR cracKsÀ
areas at Be¿RiNG surFaces aNd at ca· ²oÁe bases½
dence oF cR¿cKs »ust Be discaRdedÂ
OBserve tRansitÃoN
Ca»shafts wÄth eVi-
,
2
INspect foR da»aGe to BeaRiNg JouRNaÅs.
ÆiNoR nÇcÈs and scR¿tches
can Be Re·oved UsiNg cRocus c²othÉ
3
ChecK BeaRiNg ÊouRna²s For oUt-oF-Round to be ceRtain aRea Was not
fËatteNed dURinG tRUÌnGÍ
ÎaxÌ·uÏ acceptaBËe outÐof-Round Ìs
0±002
Ìnch ÑTÒÓµ½
ÔepÕace ca»shaft iF this toleraNce is exceeded.
(4)
ÔeÖ²ace·ent of studs.
ÔE×eR to paRaØRaph
5²5,
d
³5/6
)¸ tab²e
5-21
³5/332´,
anD ÙÚGURe
5µ¶ ·5/332´
Ûhen RepÜacÝng da»agedÞ BeNt¸ or stRipPed »echaNß
ica² dRÌàe hoUsiNG stUdsá
âaBãe
5-2¸¹
¾ecHaNica² äRive åousing StaNdard Stud IdentificatÌoN
ÔefeRence
æiG½
IteM
SettiçG
èo½
No.
NoÀ
height
Reqdá
Stud sÌze aNd length
1
/
ºµ5/32
/
±
3/8µ16 »º5/º6´
x
3/8µ2¼ ³º3/1½´
x
1-º5/16
5-5½
¼
é RÌght
³5/332´
banK
4
- ²eFt/
banK
5/332
¾
)
Back to Top
