MWO-5-2350-262-35-1
ARMORED COMBAT EARTHMOVER (ACE), M9
MODIFICATION WORK ORDER
JUNE 2005
MWO-5-2350-262-35-1 - Page 11 of 24
MWO 5-2350-262-35-1
f.
On middle fitting (4) of bracket (21), remove and discard 45˚ elbow MS51509A24 and install 35˚ elbow
(5), facing down, on bracket.
g.
Install quick-disconnect (9) at middle fitting (4) on bracket (21) with male coupling to bracket side.
h.
Remove and discard two bolts (19), washers (18), and bracket (17) from bracket (14) on hull bottom plate.
i.
Remove and discard hose 13214E2551 and tube 12325766 from bottom fitting (6) of bracket (21) and
hydraulic tank (16) bottom.
j.
Remove and discard bracket (14) from hull bottom plate, using method (1) or (2):
(1)
Remove and discard two bolts (12), washers (13), and bracket (14) from hull bottom plate.
WARNING
When cutting and grinding CARC painted equipment, ensure proper ventilation
and that personnel wear appropriate protective equipment.
Dust from grinding
CARC paint is to be treated and disposed of as hazardous waste. Failure to
comply may result in injury or death.
(2)
Using suitable aluminum cutting tool, cut and discard welded bracket (14) from hull.
(a)
Grind raw area smooth on hull bottom plate using a suitable aluminum grinding tool.
(b)
Clean, prime, and paint raw area using suitable CARC primer and finish paint per TB 43-
0209.
k.
Install quick-disconnect (8) at bottom fitting (6) on bracket (21) with male coupling to bracket side.
l.
Install new 90˚ elbow (11) on one end of new hose (15).
m.
Install female quick-disconnect half (8) to 90˚ elbow (11).
n.
Route hose (15) on hull bottom in front of steer unit (2) and install hose end on bottom of hydraulic tank
(16).
o.
Install guide pin (7) at lower rear engine mounting point.
p.
Install power package per TM 5-2350-262-34, Power Package Replacement–Installation, with following
changes:
2-6
Back to Top
