MWO-5-2350-262-35-1
ARMORED COMBAT EARTHMOVER (ACE), M9
MODIFICATION WORK ORDER
JUNE 2005
MWO-5-2350-262-35-1 - Page 12 of 24
MWO 5-2350-262-35-1
NOTE
Steps (1) through (4) below apply to Figure 2-3.
(1)
While performing TASK F per TM 5-2350-262-34, Power Package Replacement–Installation,
adjust 90˚ elbow (2) on compensating pump to face up and angle towards transfer case.
5
4
3
2
1
Figure 2-3.
Compensating Pump between Hose and Elbow
(2)
Install quick-disconnect (3) on compensating pump at elbow (2) with male coupling to
compensating pump.
(3)
Install new 90˚ elbow (4) to female half quick-disconnect coupling (3).
(4)
Reroute hose (5) up through front tubes on manifold, next to compensating pump, and above
compensating pump to 90˚ elbow (4).
NOTE
Steps (5) (a), (b), and (c) below apply to Figure 2-4.
(5)
While performing TASK J and K per TM 5-2350-262-34, Power Package Replacement–
Installation, perform the following steps:
(a) Remove and discard cap screw (9), retaining strap (8), flat washer (6), and nut (5) from
bracket (1).
(b) Remove and discard two cap screws (7), flat washers (4), nuts (3), and bracket (1) from plate
(2).
(c) Remove and discard two machine bolts (10), retaining strap (13), flat washers (11), and nuts
(12) from hull bottom plate.
2-7
Back to Top
