MWO-9-2300-378-34-2
TANK, COMBAT FULL-TRACKED
MODIFICATION WORK ORDER
JUNE 1984
MWO-9-2300-378-34-2 - Page 16 of 92
MWO 9-2300-378-34-2
10.
MODIFICATION PROCEDURES
The smoke generating system is only intended to be used on vehicles with AVDS-1790-2C and
AVDS-1790-2D engines which have electrical disconnection top of the engine. The installation
instructions for the engine portion of the system will be the same for all the vehicles intended
to be modified.
However, there are different installation instructions for the hull wiring
portion of the various vehicles.
These instructions will be divided into eight sections as follows:
Section I
Section II
Section III
Section IV
Section V
Section VI
Section VII
Section VIII
Engine Modification Instructions
Assembly of Smoke Generator Switch Bracket
Hull Wiring Instructions for M60A3 and
M60A1 (RISE) Vehicles
Hull Wiring Instructions for M60A1 and
M728 Vehicles
Hull Wiring Instructions for the M48A5 Vehicle
Hull Wiring Instructions for the M60A1
AVLB and the M48A5 AVLB
System Operation and Leak Check
Troubleshooting
Section I -
a.
Preliminary Procedures.
(1)
Disconnect the three ground
appropriate vehicle TM).
(2) Remove powerplant (refer to
(3) Remove engine shroud and
vehicle TM).
Engine Modification
straps from the battery negative terminals (refer to
appropriate vehicle TM).
rear engine shroud support (refer to appropriate
14
Back to Top
