MWO-9-2320-279-20-3
MODIFICATION OF M977 SERIES HEAVY EXPANDED MOBILITY TACTICAL TRUCK (HEMTT)
MODIFICATION WORK ORDER; INSTALLATION INSTRUCTIONS FOR NATO SLAVE RECEPTACLE RELOCATION
JULY 1992
MWO-9-2320-279-20-3 - Page 10 of 17
MWO 9-2320-279-20-3
(4) Apply grease (item 2, Table 5) to two
(7) Install cover (15) on box (4) with four
grommets (9). Insert negative battery ca-
screws (#10-32) (16).
ble (10) and positive battery cable (11)
through grommets and into box as shown
e. Installation of NATO Slave Receptacle and
below.
Box.
NOTE
Install ties (item 3, Table 5) as
necessary.
(1) Open engine cover on driver’s side and
remove engine cover side panel.
(5)
(6)
8
Install two battery cables (10) and (11) on
receptacle (1) and secure each with
Iockwashers (12) and screws (13).
WARNING
Adhesives, solvents, and sealing
compounds can burn easily, can
give off harmful vapors, and are
harmful to skin and clothing. To
avoid injury or death, keep away
from open fire and use in well-ven-
tilated area. If adhesive, solvent,
or sealing compound gets on skin
or clothing, wash immediately with
soap and water.
Apply silicone adhesive sealant to both
sides of gasket (14) and install gasket in
cover (15).
(2)
(3)
Mount slave box (1) on fender (2) with four
5/1 6 bolts (3) and four locknuts (4).
Install cushion clip clamp (5) (furnished
with kit), washer (6), screw (7), washer (8),
Iockwasher (9), and nut (10).
Back to Top
