MWO-9-2330-390-25-1
MODIFICATION WORK ORDER
MODIFICATION OF M1022A1 DOLLY SET; POSITIONING TUBE REINFORCEMENT
DECEMBER 2006
CHANGE 1
MWO-9-2330-390-25-1 - Page 11 of 54
MWO 9-2330-390-25-1
9
(3)
For off-line reporting, the 3.5-inch disk shall be mailed to the following
address:
Commander
TACOM-Warren
ATTN: AMSTA-LC-CIPWM
Warren, MI 48397-5000
b.
Marking Equipment.
(1)
After the Positioning Tube Reinforcement Kit is installed, mark MWO
under 9-2330-390-25-1 in the MWO Applied block and Date Applied in
Date Block on MWO instruction plate P/N 10930014 (91).
(2)
To install the MWO instruction plate, locate a single 0.107
inch diameter
hole (#37 - drill size) on the front upper left (hydraulic valve side) vertical
tube above the instruction plate (see figure 9). Use #4-3/16 drive screws
(32) to attach.
15.
MATERIAL CHANGE (MC) NUMBER.
a.
The Material Change (MC) Number for this MWO is 1-05-08-0001
16.
MODIFICATION IDENTIFICATION.
a.
When installed correctly, the Positioning Tube Reinforcement Kit will appear as
shown in figure 7.
b.
After the Positioning Tube Reinforcement Kit is installed, the positioning tube
reinforcement should be inspected for secure mounting. Any faults detected, or
discrepancies noted, will be corrected before the dolly is returned to normal
service.
Back to Top
