TB-9-2300-378-14

M48 & M60 SERIES VEHICLES

TECHNICAL BULLETIN; AIR INDUCTION SYSTEM MAINTENANCE

SEPTEMBER 1985

  TB-9-2300-378-14 - Page 48 of 296

TB 9-2300-378-14
NOTE
A suitable washing vat can be fabricated using the following
suggested procedures:
(a)
(b)
(c)
Obtain a 55 gallon drum, approximately 23 inch diameter and 34 inch high.
Thoroughly clean out drum (steam clean).
Remove one end of drum (preferably the end with plugs in it). Minimum
height of drum must be 23 inches.
Obtain a length of 5/8 or 3/4 inch water hose sufficient to cover cut edges of
drum.
(d)
(e)
Split water hose lengthwise and position on cut edge of drum. This will
prevent filter element damage from the cut edge.
3-5. Final Drive and Fuel Tank Vent Systems Inspection.
a.
Fuel Tank Vent System (Fig. 3-6).
Figure 3-6. Fuel tank vent system inspection.
3-28


Back to Top