TB-9-2320-279-13-P-2

TECHNICAL BULLETIN; CREW PROTECTION KIT

OPERATOR’S, UNIT AND DIRECT SUPPORT MAINTENANCE MANUAL, INSTALLATION INSTRUCTIONS, AND REPAIR PARTS AND SPECIAL TOOLS LISTS (RPSTL)

SEPTEMBER 2005

TB-9-2320-279-13-P-2 - Page 310 of 460

II106700-5

Rev. B

Page 46

5.1.4

Install the Headlights

a.

In order to install the Headlight Assemblies, it is necessary to identify which type of

Marker Light is used on the vehicle.

Before being removed, the Marker Light was

located just inboard of the Headlight.

Inspect the Marker Light and determine whether

an incandescent bulb (i.e., a common lamp bulb) is used inside the light.

If an

incandescent bulb is

NOT

found, install the Headlight Assemblies using Steps b, c, e,

and f, as the Adapter, P/N 111442-1, is not required.

If an incandescent bulb

IS

found,

install using Steps b through f.

b.

Install the LH Headlight Bracket (P/N 111418-1) (See Figure 28) using two bolts

(3/8 – 16 x 1.500 LG) and four washers (3/8 ID) in the top holes.

Then, install

three bolts (3/8 – 16 x 1.500 LG), six washers (3/8 ID), and three locknuts

(3/8 – 16) in the bottom holes of the Headlight Bracket.