TB-9-2320-302-13-P-1

CREW PROTECTION KIT PART 1 OF 3

TECHNICAL BULLETIN; OPERATOR’S, UNIT AND DIRECT SUPPORT, MAINTENANCE MANUAL, INSTALLATION INSTRUCTIONS, AND REPAIR PARTS AND SPECIAL TOOLS LISTS

NOVEMBER 2006

TB-9-2320-302-13-P-1 - Page 117 of 380

TB 9-2320-302-13&P-1

A-PILLAR ARMOR REPLACEMENT - CONTINUED

0022 00

0022 00-3/(0022 00-4 Blank)

REMOVAL - CONTINUED

WARNING

Use extreme caution when handling heavy parts. Provide adequate support and use assistance during proce-

dure. Failure to follow this warning may cause injury to personnel.

NOTE

A-pillar armor weighs 93 lb (42 kg) estimated.

4.

With assistance, remove six bolts (6), washers (7), A-pillar overlap (3), and A-pillar armor (8) from vehicle.

CLEANING AND INSPECTION

Clean and inspect all parts IAW

General Maintenance Instructions

(WP 0011 00).

INSTALLATION

WARNING

Use extreme caution when handling heavy parts. Provide adequate support and use assistance during proce-

dure. Failure to follow this warning may cause injury to personnel.

NOTE

A-pillar armor weighs 93 lb (42 kg) estimated.

1.

With assistance, install A-pillar armor (8), A-pillar overlap (3), six washers (7), and bolts (6) on vehicle.

2.

Install washer (12), bushing (11), bolt (13), washer (10), and nut (9) on A-pillar armor (8).

3.

Install two washers (4) and bolts (5) on bottom of A-pillar overlap (3).

4.

Install nine washers (2) and bolts (1) on A-pillar overlap (3).

5.

Install door assembly (WP 0012 00).

6.

Install front armor (WP 0029 00).

END OF WORK PACKAGE