TB-9-2320-302-13-P-1
CREW PROTECTION KIT PART 1 OF 3
TECHNICAL BULLETIN; OPERATOR’S, UNIT AND DIRECT SUPPORT, MAINTENANCE MANUAL, INSTALLATION INSTRUCTIONS, AND REPAIR PARTS AND SPECIAL TOOLS LISTS
NOVEMBER 2006
TB-9-2320-302-13-P-1 - Page 6 of 380
TB 9-2320-302-13&P-1
d
WARNING
SOLVENT CLEANING COMPOUND
•
Solvent cleaning compound MIL-PRF-680 Type III is an environmentally compliant and low toxic
material. However, it may be irritating to the eyes and skin. Use protective gloves and goggles. Use in
well-ventilated areas. Keep away from open flames and other sources of ignition. Failure to follow this
warning may cause injury to personnel.
•
Improper cleaning methods and use of unauthorized cleaning solvents may injure personnel and damage
equipment. Refer to TM 9-247,
Materials Used for Cleaning, Preserving, Abrading, and Cementing
Ordnance Materiels and Related Materiels Including Chemicals
, for correct information.
•
Fire extinguishers should be placed nearby when using solvent cleaning compound.
•
Cloths or rags saturated with solvent cleaning compound must be disposed of IAW authorized facilities’
procedures.
•
Eye shields must be worn when cleaning with a wire brush. Flying rust and metal particles may cause
injury.
•
Particles blown by compressed air are hazardous. DO NOT exceed 15 psi (103 kPa) nozzle pressure
when drying parts with compressed air. Use a maximum of 30 psi (207 kPa) when cleaning compo-
nents. DO NOT direct compressed air against human skin. Failure to follow this warning may result in
injury or death. Make sure air stream is directed away from user and other personnel in the area. To pre-
vent injury, user must wear protective goggles or face shield.
WARNING
THREAT PROTECTION
For proper threat protection, ballistic glass must be correctly installed onto ballistic glass frame. During
installation, ensure that decal “INSTALL THIS SURFACE TOWARDS THREAT” is located on outside of
cab. Improperly installed windshield ballistic glass will not protect occupants. Failure to follow this warning
may cause injury or death to personnel.
WARNING
WELDING NOT AUTHORIZED
To ensure survivability of personnel, welding repairs on armor kit are NOT authorized. If armor plates are
damaged, they must be replaced. Failure to follow this warning may cause failure of armor, resulting in
injury or death to personnel.
Back to Top
