TB-9-2320-302-13-P-2
CREW PROTECTION KIT PART 2 OF 3
TECHNICAL BULLETIN; OPERATOR'S, UNIT AND DIRECT SUPPORT, MAINTENANCE MANUAL, INSTALLATION INSTRUCTIONS AND REPAIR PARTS AND SPECIAL TOOLS LIST
JUNE 2007
TB-9-2320-302-13-P-2 - Page 162 of 396
TB 9-2320-302-13&P-2
RIGHT FIREWALL ARMOR REPLACEMENT - CONTINUED
0028 00
0028 00-4
REMOVAL - CONTINUED
5.
Remove locknut (18), washer (19), bolt (21), washer
(20), and bracket (6) from radiator core support (22).
Discard locknuts.
CLEANING AND INSPECTION
Clean and inspect all parts IAW
General Maintenance Instructions
(WP 0011 00).
INSTALLATION
1.
Install bracket (6), washer (20), bolt (21), washer (19), and new locknut (18) on radiator core support (22).
WARNING
•
Use extreme caution when handling heavy parts. Provide adequate support and use assistance during
procedure. Failure to follow this warning may cause injury or death to personnel.
•
For proper threat protection, armor must be installed correctly into the armor frame. During installation,
ensure that the surface marked “STRIKE FACE” is facing outward towards the threat. Exposing the
passive side of the ballistic panel outward makes the armor less effective. Failure to follow this warning
may cause injury or death to personnel.
2.
With assistance, install right firewall armor (5), two washers (9), bolts (10), washers (8), and new locknuts (7) on
bracket (6).
3.
Install two new lockwashers (12), washers (13), and bolts (11) on right firewall armor (5).
440-040
22
18,19,20,21
6
Back to Top
