TB-9-2320-302-13-P-3
CREW PROTECTION KIT; AIR CONDITIONING KIT PART 3 OF 3
TECHNICAL BULLETIN; OPERATOR’S, UNIT, AND DIRECT SUPPORT, MAINTENANCE MANUAL, INSTALLATION INSTRUCTIONS, AND REPAIR PARTS AND SPECIAL TOOLS LIST
MARCH 2008
TB-9-2320-302-13-P-3 - Page 5 of 240
TB 9-2320-302-13&P-3
c
FOR INFORMATION ON FIRST AID, REFER TO FM 4-25.11.
Use caution when using adhesives and sealants. Prolonged inhalation of vapors can cause lung irritation.
Contact with skin can cause dermatitis. Wear gloves and safety goggles and use product in a well-ventilated
area away from open flame. If ingested, keep individual calm and seek medical attention. DO NOT induce
vomiting. If contact with skin or eyes is made, flush thoroughly with water. Dispose of cleanup rags IAW
local policy and ordinances. Failure to follow this warning may cause injury to personnel.
Particles blown by compressed air are hazardous. DO NOT exceed 15 psi (103 kPa) nozzle pressure when
drying parts with compressed air. Use a maximum of 30 psi (207 kPa) when cleaning components. DO NOT
direct compressed air against human skin. Make sure air stream is directed away from user and other person-
nel in the area. To prevent injury, user must wear protective goggles or face shield. Failure to follow this
warning may result in injury or death to personnel.
Before removing any component of electrical system, be sure battery disconnect switch is in OFF position.
Remove all jewelry before working on electrical system. Failure to follow this warning may cause injury to
personnel.
Use caution when handling heavy parts. Provide adequate support and use assistance during procedure.
Ensure that any lifting device used is in good condition and of suitable load capacity. Keep clear of heavy
parts supported only by lifting device. Failure to follow this warning may cause injury or death to personnel.
WARNING
ADHESIVES AND SEALANTS
WARNING
COMPRESSED AIR
WARNING
ELECTRICAL
WARNING
HEAVY COMPONENTS
Back to Top
