TB 9-2320-335-13&P
4-4
4-17.1. SPEEDOMETER/ODOMETER (ELECTRONIC) REPLACEMENT
This task covers:
a. Removal
b. Installation
INITIAL SETUP:
Tools
General mechanic’s tool kit:
automotive (Appendix B, Item 1)
Maintenance and repair shop equipment:
automotive (Appendix B, Item 2)
Manual References
TM 9-2320-387-10
TM 9-2320-387-24-1
TB 9-2320-335-13&P, Appendix E
Equipment Condition
Battery cables disconnected
(TM 9-2320-387-24-1).
Maintenance Level
Unit
1.
Remove four capscrews (11), washers (10), and instrument cluster (1) from instrument panel (2).
2.
Remove harness assembly nut (7) from rear of speedometer (13).
3.
Remove two nuts (6), washers (5), washers (4), ground wire 58M (3), and shielding ground wire (8) from
retaining bracket (9) on rear of speedometer (13).
4.
Remove retaining bracket (9) from two threaded studs (12) on rear of speedometer (13) and remove
speedometer (13) from instrument cluster (1).
1.
Install retaining bracket (9) on two threaded studs (12) on rear of speedometer (13).
2.
Install ground wire 58M (3) and shielding ground wire (8) on two threaded studs (12) on rear
of speedometer (13) with two washers (4), washers (5), and nuts (6). Tighten nuts (6) to
5 lb-in (0.6 N
•
m).
3.
Install harness assembly nut (7) on rear of speedometer (6).
4.
Install instrument cluster (1) into instrument panel (2) with four capscrews (11) and washers (10).
b. Installation
a. Removal