TB-9-2320-335-13-P

TRUCK, UTILITY: EXPANDED CAPACITY, IAP/ARMOR READY

TECHNICAL BULLETIN; OPERATOR AND FIELD MAINTENANCE AND REPAIR PARTS AND SPECIAL TOOLS LIST (RPSTL) INSTRUCTIONS

MAY 2008

TB-9-2320-335-13-P - Page 158 of 680

TB 9-2320-335-13&P

5-17.1. SENDER GENERATOR (ELECTRONIC) REPLACEMENT

5-8

This task covers:

a. Removal

b. Installation

INITIAL SETUP:

Tools

General mechanic’s tool kit:

automotive (Appendix B, Item 1)

Materials/Parts

Two tiedown straps (Appendix A, Item 324)

Manual References

TM 9-2320-387-24-1

TB 9-2320-335-13&P, Appendix E

Equipment Condition

Battery cables disconnected (TM 9-2320-387-24-1).

Maintenance Level

Unit

1.

Remove tiedown strap (9) and shielding sleeve (10) from sender generator (4). Discard tiedown

strap (9).

2.

Remove tiedown strap (8) and excess wiring (3) from sender generator (4). Discard tiedown strap (8).

3.

Disconnect speedometer harness connector (1) from sender generator harness connector (2).

4.

Remove sender generator (4) from pinion adaptor (5) on transfer case (6).

NOTE

Sender generator drive tang can be removed if necessary to replace.

5.

Remove sender generator drive tang (7) from sender generator (4).

NOTE

Place any excess wiring inside sender generator shielding sleeve.

1.

Install sender generator tang (7) in sender generator (4).

2.

Install sender generator (4) on pinion adapter (5) on transfer case (6).

3.

Connect speedometer harness connector (1) to sender generator harness connector (2).

4.

Install excess wiring (3) on sender generator (4) with tiedown strap (8).

5.

Install shielding sleeve (10) on sender generator (4) with tiedown strap (9).

b. Installation

a. Removal